Maintenance/Software/Image Select - i3 International S241 User Manual

Parameters:
Items
Buttons
WEB Interface:
A. Click Maintanence

Maintenance/Software/Image Select

Using Software Image Selection page to swap the firmware to alternative image.
LOCATION：Maintenance>Software>Image Select
Parameters:
Items Description
Image The flash index name of the firmware image. The name of primary (preferred) image
is image, the alternate image is named image.bk.
Version The version of the firmware image.
Date The date where the firmware was produced.
Buttons
disabled depending on system state
WEB Interface:
A. Click Maintanence
Description
to the location of a software image and click
After the software image is uploaded, a page announces that the firmware update is
initiated. After about a minute, the firmware is updated and the switch restarts.
Warning: While the firmware is being updated, Web access appears to be
defunct. The front LED flashes Green/Off with a frequency of 10 Hz while the
firmware update is in progress. Do not restart or power off the device at this time or
the switch may fail to function afterwards.
/Software/Upload
：Cancel activating the backup image. Navigates away from this page.
/Software/Image Select
and browse the firmware file then click Upload.
： Click to use the alternate image. This button may be
to swap to alternative image.
150