Security/Switch/Rmon/Event; Security/Network/Limit Control - i3 International S241 User Manual

Security/Switch/RMON/Event

Using RMON Event Configuration page to setup a trigger when the condition is happened in the Alarm group.
LOCATION：Configuration>Securtiy>RMON>Event
Parameters:
Items
Delete
ID
Desc
Type
[none]
[log]
[snmptrap]
[logandtrap]
Community
Event Last Time
WEB Interface:
Configuration/Security/Switch/RMON/Event
A. Click
B. Click "Add New Entry" to create a new rule
C. Set ID, sampling interval, MIBs variable, Sample type, Startup Alarm timing, Rising threshold, Rising Index, Falling
Threshold, Falling Index.
D. Click Save to apply the setting or Reset to restore the previous setting.

Security/Network/Limit Control

Use the port Security Limit Control configuration page to limit the number of users accessing the specific port. A user is
identified by a MAC address and VLAN ID. If Limit Control is enabled on a port, the limit specifies the maximum number of
users on the port. If this number is exceeded, an action is taken. The action can be one of the four different actions as
described below.
LOCATION：Configuration>Security>Network>Limit Control
Description
Delete the Entry of Event configuration.
Indicates the index of the entry. The range is from 1 to 65535.
Indicates this event, the string length is from 0 to 127, default is null string.
Indicates the notification of the event, the possible types are:
The total number of octets received on the interface, including framing characters.
The number of uni-cast packets delivered to a higher-layer protocol.
The number of broad-cast and multi-cast packets delivered to a higher-layer protocol.
The number of inbound packets that are discarded even the pakets are normal.
Specify the community when trap is sent, the string length is from 0 to 127, default is "public"
Indicates the value of sysUpTime at the time this event entry last generated an event
34