Main Pcba Replacement - FujiFilm SonoSite sII Service Manual

8 Remove eight screws as shown in
9 Lift Main PCBA from Mid-Frame

Main PCBA Replacement

1 Place Main PCBA on Mid-Frame and install seven screws as shown in
screws.
2 Tip Mid-Frame onto the side and Install Nest Frame Assembly with four screws as shown in
Torque to 5.5 in-lbs.
3 Tighten screws previously installed on Main PCBA to 5.5 in-lbs.
4 Install TGC cable.
5 Install speaker wires.
6 Install power cable to the Dual Fan Assembly.
Remove
screws (7x)
speaker wire
Figure 6.18 Main PCBA
52 Chapter 6: Replacement Procedures
Figure 6.18.
Figure 6.18. Do not tighten the
Figure
Dual Fan
Assembly
power cable
TGC cable
speaker wire
6.19.