Installation - Interlogix XTI-5 Installation Manual

Installation

Mounting
Figure 3: XTi chassis and trim ring
To mount the panel on a wall:
1. Lay the panel flat on a table.
2. Remove trim ring (B in Figure 3 above) from panel by lifting at notch (C in
Figure 3 above).
3. Separate the panel chassis from the mounting plate by lifting up on the tabs
(A in Figure 3 above) and swinging the chassis open.
4. Choose a panel location.
5. Run all necessary power, phone, siren, and hardwired contact wires to the
desired panel location.
Note: When choosing the AC outlet location for the AC power transformer,
make sure the outlet is not controlled by a switch or that it is not part of a
ground fault circuit interrupt (GFCI).
6. Hold the mounting plate against the wall and mark the mounting hole
locations (Figure 4) with a pencil.
Note: Mark both mounting holes in the middle of the mounting slot. This will
allow better adjustment of the panel before securing it to the wall.
14 Simon XTi-5 Installation Manual Contents