System Components - Interlogix XTI-5 Installation Manual

System components

The system can monitor up to 40 sensors and may use any of the devices listed
in Table 1 below.
Table 1: Supported devices
Device
Max Life Door/window sensor
(60-362N-10-319.5)
Indoor motion sensor
(60-639 & 60-807-95)
Smoke sensor
(TX-6010-01-1)
Glassbreak sensor (60-873-
95)
Carbon monoxide (CO) alarm
(TX-6310-01-1/600-6520-95)
4-Button Key fob
(600-1064-95R)
Simon XT Talking Touchpad
(60-924-3-XT)
2
Description
For intrusion protection, install door/window sensors on all
ground-floor doors and windows. At a minimum, install them in the
following locations:
•
All easily accessible exterior doors and windows.
•
Interior doors leading into the garage.
•
Doors to areas containing valuables.
Indoor motion sensors are ideal whenever it is not practical to
install door/window sensors on every opening. Identify areas
where an intruder is likely to walk through. Large areas in an open
floor plan, downstairs family rooms, and hallways are typical
locations for indoor motion sensors. For installations with pets,
use the SAW Pet Immune PIR (60-807-95).
Smoke sensors provide fire protection by causing an alarm to
sound throughout the house. You can add smoke sensors near
sleeping areas and on every floor of the house. Avoid areas that
could have some smoke or exhaust such as attics, kitchens,
above fireplaces, dusty locations, garages, and areas with
temperature extremes. In these areas, you may want to install
rate-of-rise sensors to detect extreme temperature changes. See
the instructions packaged with the smoke sensor for complete
placement information.
Glassbreak sensors respond to shock waves of breaking glass.
These sensors are designed to mount in the corner of windows or
doors, either on the frame or on the glass itself. See the
instructions packaged with the glassbreak sensor for complete
placement information.
The learn mode CO alarm alerts you to hazardous levels of
carbon monoxide gas. If dangerous concentrations of gas are
present, the red indicator light comes on, the internal siren goes
off, and an alarm is transmitted to the panel. The panel sounds its
own alarm and reports to the central station.
The key fob (keychain touchpad) lets you turn the system on and
off from right outside the home or activate a panic alarm if there is
an emergency. If you have the appropriate light control modules,
you can use key fobs to turn all system controlled lights on and
off.
The wall-mounted, two-way, talking touchpad combines a
conventional learn mode touchpad with an RF receiver, speech
chip, and voice amplification circuit.
Simon XTi-5 Installation Manual Contents