Advanced Installation
Reset to Factory Default
Follow these steps to reset your ZeroWire back to factory default settings:
1.
YOUR 4 OR 6 DIGIT INSTALLER CODE
2.
3.
4.
MENU
5.
Reset Installer Account
Lost your installer PIN code? Follow these steps to reset it:
1. Use a small screwdriver to hold down the reset button before you turn on power.
2. Wait 3 seconds after turning on the power, then release the reset button. This will reset
user 40 to PIN 9713 and username "installer".
Switch Connection Modes
A few connection methods are supported:
1. WiFi Discovery Mode – this provides direct access to the ZeroWire from a mobile
device such as a smart phone or tablet for programming settings and initial set up only.
2. Wireless LAN Setup – this connects the ZeroWire to a local WiFi network. You will
need to provide an internet connection and wireless router for the permanent
connection. A mobile device such as a smart phone or tablet is needed to set up this
connection.
3. Wired LAN Setup – this is the easiest to set up but requires a physical Ethernet
connection to the ZeroWire. You will need to also provide the internet connection and
Ethernet router.
ZeroWire Installation Manual
MENU
9
ENTER
0
BYPASS
MENU
MENU
Select main menu - Option 9.
Enter your Installer code.
Select resetting to the factory defaults.
Confirm by pressing the BYPASS key, and then wait
for 10 seconds.
Exit from the menu.
19