Installing A Switch; Installation On A Din Rail - Siemens SCALANCE X-300 Manual

5.2

Installing a switch

Electrical connections
Make sure that the power supply of the switch is turned off when fitting the connectors for
the power supply and the signaling contacts.
For information on the electrical connections, refer to Section Connecting (Page 121).
5.2.1

Installation on a DIN rail

No installation on a 35 mm DIN rail in shipbuilding
In ships, the 35 mm DIN rail does not provide adequate support.
This applies to all devices with this notice in the "Installation options" table in the section
"Technical specifications" (subsection, "Construction, installation and environment").
Installation
Install the IE Switch X-300 on a 35 mm DIN rail complying with IEC 60715.
1. Hang the IE Switch X-300 on the DIN rail and then push it in against the rail until it clips
2. Connect the grounding of the switch according to the description in the section
3. Fit the connectors for the power supply.
4. Fit the connectors for the signaling contact.
5. Insert the terminal blocks into the sockets on the IE Switch X-300.
SCALANCE X-300
Operating Instructions, 10/2010, A5E01113043-10
CAUTION
WARNING
into place.
Connecting the grounding (Page 122).
Figure 5-1 Mounting an IE Switch X-300 on a DIN rail (35 mm)
Installation
5.2 Installing a switch
99