Siemens SCALANCE X-300 Manual page 231

● Keep to the installation guidelines
● Working on the product
Machinery directive
The product is a component in compliance with the EC Machinery Directive 2006/42//EEC.
According to the machinery directive, we are obliged to point out that the product described
is intended solely for installation in a machine.
Before the final product can be put into operation, it must be tested to ensure that it conforms
with the directive 2006/42/EEC.
Note
Note for the manufacturers of machines
This product is not a machine in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 2006/42/EEC for this
product.
SCALANCE X-300
Operating Instructions, 10/2010, A5E01113043-10
The product meets the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the product.
The very latest documentation is available on the Internet!
You will find the installation instructions documentation on the Internet on the pages of
Siemens Industry Automation Customer Support under the following entry ID:
– SIMATIC NET Industrial Twisted Pair and Fiber Optic Networks Manual
8763736
– EMC Installation Guideline, Planning Guide
28518276
To protect the product from electrostatic discharge, personnel must first discharge any
electrostatic charge from their body before touching the product.
NOTICE
The product was tested with a device that also complies with the standards listed above.
If the product is operated with a device that does not meet these standards, there is no
guarantee that the corresponding values will be adhered to.
Approvals, certificates, standards
9.6 Product group X-300M PoE
231