Siemens SCALANCE X-300 Manual page 220

Approvals, certificates, standards
9.4 X-300EEC product group
● Installation guidelines
● Working on the product
Machinery directive
The product remains a component in compliance with Article 4 (2) of the EC Machinery
Directive 89/392/EEC.
According to the machinery directive, we are obliged to point out that the product described
is intended solely for installation in a machine.
Before the final product can be put into operation, it must be tested to ensure that it conforms
with the directive 89/392/EEC.
Note
Note for the manufacturers of machines
This product is not a machine in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 89/392/EEC for this
product.
220
The product meets the requirements if you adhere to the installation and safety notices
contained in this documentation and in the following documentation when installing and
operating the product.
The very latest documentation is available on the Internet!
You will find the installation instructions documentation on the Internet on the pages of
Siemens Industry Automation Customer Support under the following entry ID:
– SIMATIC NET Industrial Twisted Pair and Fiber Optic Networks Manual
8763736 (http://support.automation.siemens.com/WW/view/en/8763736)
– EMC Installation Guideline, Planning Guide
28518276 (http://support.automation.siemens.com/WW/view/en/28518276)
To protect the product process from electrostatic discharge, personnel must first
discharge any electrostatic charge from their body before touching the product.
NOTICE
The product was tested with a device that also complies with the standards listed above.
If the product is operated with a device that does not meet these standards, there is no
guarantee that the corresponding values will be adhered to.
Operating Instructions, 10/2010, A5E01113043-10
SCALANCE X-300