Pci-X Mezzanine Board - HP ProLiant BL40p Maintenance And Service Manual

PCI-X Mezzanine Board

To remove the PCI-X mezzanine board:
1. Power down the server blade and remove it from the server blade enclosure. Refer to
"Server Blad e Preparation" in this chapter.
2. Remove the access panel and the system board tray assembly. Refer to "Server Blade
Preparation" in this chapter.
3. Disconnect RJ-45 cables from the PCI-X mezzanine board.
4. Remove any host-bus adapter cards installed in the PCI-X mezzanine board. Refer to
"Host-Bus A dapter Cards" in this chapter.
5. Simultaneously raise the two slate blue release levers to a 90° angle (1).
6. Lift the PCI-X mezzanine board off of the system board (2).
Figure 2-29: Removing the PCI-X mezzanine board
Reverse steps 1 through 6 to replace the PCI-X mezzanine board.
HP ProLiant BL40p Server Blade Maintenance and Service Guide
Removal and Replacement Procedures
2-29