8.
Remove the top cover (2).
Reverse this procedure to install the top cover.
Fingerprint reader board
Description
Fingerprint reader board (includes bracket and cable)
Before removing the power button board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Hard drive (see
b.
Memory module service cover (see
c.
Optical drive (see
d.
Keyboard (see
e.
Top cover (see
Remove the fingerprint reader board:
1.
Disconnect the fingerprint reader ribbon cable from the board (1).
2.
Remove the Phillips PM2.0×4.0 screw (2) that secures the fingerprint reader bracket to the top cover.
3.
Lift the fingerprint reader bracket up off of its alignment pins and out of its slot in the top cover (3).
Battery on page
33) and then remove the following components:
Hard drive on page
34)
Memory module on page
Optical drive on page
Keyboard on page
46)
Top cover on page
49)
40)
42)
Component replacement procedures
Spare part number
725239-001
51