Display Assembly Subcomponents - HP 242 G2 Maintenance And Service Manual

Reverse this procedure to install the speakers.

Display assembly subcomponents

NOTE: The display assembly is spared at the subcomponent level only. For more display assembly spare
part information, see the individual removal subsections.
A Raw panel support kit is available using spare part number 724299-001.
To remove the display assembly and access the display assembly subcomponents, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive (see
b. WLAN module (see
c. Solid-state drive (see
d. Memory module service cover (see
e. Optical drive (see
f. Keyboard (see
g. Top cover (see
h. Fan (see
i. System board (see
Remove the display assembly:
1. Release the display panel cable (1) from the clips and routing channel built into the base enclosure.
2. Release the wireless antenna cables (2) from the clips and routing channel built into the base enclosure
and right display hinge.
3. Remove the six Phillips PM2.5×4.5 screws (3) that secure the display assembly to the top cover.
Battery on page
Hard drive on page
WLAN module on page
mSATA drive on page
Optical drive on page
Keyboard on page
Top cover on page
Fan on page 56)
System board on page
33) and then remove the following components:
34)
37)
39)
Memory module on page
42)
46)
49)
59)
40)
Component replacement procedures 69