HP 242 G2 Maintenance And Service Manual page 82

a. Release the grounding tape (1) that secures the left display hinge to the display enclosure.
b. Remove the four Phillips PM2.5×3.0 screws (2) that secure the display hinges to the display
enclosure.
c. Remove the display hinges (3).
The display hinges are available using spare part number 728282-001.
8. If it is necessary to replace the display panel:
a. Remove the eight Phillips PM2.0×2.5 screws (1) that secure the display panel to the display
enclosure.
CAUTION:
tools, screws, and any other foreign objects. Failure to follow this caution can result in damage to
the display panel.
b. Lift the top edge of the display panel (2), and then swing it up and forward until it rests upside
down in front of the display enclosure.
72 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Before turning the display panel upside down, make sure the work surface is clear of