Dynamically Choosing A Boot Device Using The F9 Prompt; Setting A Multiboot Express Prompt; Entering Multiboot Express Preferences; Using Hp Pc Hardware Diagnostics (Uefi) - HP 242 G2 Maintenance And Service Manual

Table of Contents

Advertisement

Dynamically choosing a boot device using the f9 prompt

To dynamically choose a boot device for the current startup sequence, follow these steps:
1.
Open the Select Boot Device menu by turning on or restarting the computer, and then pressing
the "Press the ESC key for Startup Menu" message is displayed at the bottom of the screen.
2.
Press f9.
3.
Use a pointing device or the arrow keys to select a boot device, then press enter.

Setting a MultiBoot Express prompt

To start Computer Setup and set the computer to display the MultiBoot startup location menu each time the
computer is started or restarted, follow these steps:
1.
Turn on or restart the computer, and then press
message is displayed at the bottom of the screen.
2.
Press
f10
3.
Use a pointing device or the arrow keys to select Advanced > Boot Options > MultiBoot Express Boot
Popup Delay (Sec), and then press enter.
4.
In the MultiBoot Express Popup Delay (Sec) field, enter the length of time in seconds that you want the
computer to display the startup location menu before it defaults to the current MultiBoot setting.
(When 0 is selected, the Express Boot startup location menu is not displayed.)
5.
To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of the
screen, and then follow the on-screen instructions.
– or –
Use the arrow keys to select Main > Save Changes and Exit, and then press enter.
Your changes go into effect when the computer restarts.

Entering MultiBoot Express preferences

When the Express Boot menu is displayed during startup, you have the following choices:
To specify a boot device from the Express Boot menu, select your preference within the allotted time,
and then press enter.
To prevent the computer from defaulting to the current MultiBoot setting, press any key before the
allotted time expires. The computer will not start until you select a boot device and press enter.
To allow the computer to start according to the current MultiBoot settings, wait for the allotted time to
expire.

Using HP PC Hardware Diagnostics (UEFI)

HP PC Hardware Diagnostics is a Unified Extensible Firmware Interface (UEFI) that allows you to run
diagnostic tests to determine whether the computer hardware is functioning properly. The tool runs outside
the operating system so that it can isolate hardware failures from issues that are caused by the operating
system or other software components.
To start HP PC Hardware Diagnostics UEFI:
to enter Computer Setup.
esc
while the "Press the ESC key for Startup Menu"
Using HP PC Hardware Diagnostics (UEFI)
esc
while
79

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents