Background Music/Music-On-Hold; Guidelines; Installation - Panasonic CPC-EX Installation Manual

Chapter 5. Peripheral Equipment

Background Music/Music-On-Hold

Guidelines

• A single music source can be used for both background music (BGM) and
• If a single music source is used for both MOH and BGM, the music source
• If an FM radio is connected to the BGM connector on the SCC, install it at
• The maximum input impedance of both terminals is 10k ohms. The
• Beginning with CPC-AII and CPC-B Version 7.0, an internal hold tone

Installation

1. If you are using a single source for both BGM and MOH, connect the
2. Strap the CN5 block (SCC-A) or the CN4 block (SCC-B) according to
5-8
music-on-hold (MOH), or separate music sources can be used for each
feature.
connects to CN5 on the Connector Panel. If separate sources are used, the
MOH source connects to CN5, and the BGM source connects to the BGM
connector on the SCC card.
least 16.5 ft. (5m) away from the main cabinet. If it is too close, the
receiver may not function properly.
maximum signal level is -10 dB.
may be selected in programming. If selected, the internal hold tone will
always be used even if a sound source is connected to MOH connector
CN5.
source to CN5 on the Connector Panel. If using separate sources, connect
the MOH source to CN5 and the BGM source to the BGM connector on
the SCC card.
the number of music sources used.
To route the music from ...
A single source
Separate sources
DBS Manual - Revised April 2000
Section 300-Installation
Do this ...
Short pin 3 to 2.
Short pin 1 to 2.
DBS-2.3/9.2-300