System Initialization; Figure 3-17. Cpc Memory Clear Switch - Panasonic CPC-EX Installation Manual

Section 300-Installation

System Initialization

1. Confirm that the DBS power switch is OFF.
2. Plug the power cord into a dedicated 120V 15 amp AC wall outlet.
3. Set SW1 on the CPC card to RAMCLR (RAM Clear).

Figure 3-17. CPC memory clear switch

TRK1 TRK2 TRK3
4. Turn the power switch on.
5. Once the bottom LED lamp on the CPC card stops flashing, set SW1 on
DBS-2.3/9.2-300
Note: A surge protector should be installed on the power cord.
EC1 EC2 EC3 EC4 EC5 EC6 EC7
As the system loads, the bottom LED lamp on the CPC card will flash.
the CPC to RAMHOLD.
DBS Manual - Revised April 2000
EC8 EC/ TRK SCC CPC AUX1 AUX2
Chapter 3. Cabinet Installation
STATU S
LED
SW 1
RAM H O LD
RAM C LR
3-17