Advantech PCM-4862 Manual page 73

All-in-one 486 single board computer with svga, ethernet, and ssd

Hide thumbs Also See for PCM-4862:

Table of Contents

Enlarged version

Step 6: At this point the Installation Menu will prompt you for the

name of your new Lotus configuration file. The Lotus system will

prompt you with the default value — 123.SET, but you may want

to use a filename that indicates the resolution of its driver. For

example, if you installed the 132 column by 25 line driver, you

could name this driver 132X25.SET, or if you installed the 80 by

50 driver, you may want to call the file 80X50.SET.

Step 7: The installation of your Lotus 1-2-3 driver is now com-

plete. You will need to exit the Lotus installation program at this

point. At the main Lotus Installation Menu, select Exit.

NOTE: If your driver set is not 123.SET, you have to type the

filename of your driver set in the command line when you start

Lotus 1-2-3. For example, if you named your driver set

132X25.SET, type the following to start Lotus 1-2-3:

123 132X25.SET <ENTER>

Chapter 5 SVGA Setup

Table of Contents