Memory Devices - Advantech PCM-4862 Manual

*System reset
J23
J24
* default setting
This section will explain the function and configuration of the
jumpers necessary for the operation of the PCM-4862's solid state
disk (SSD). The SSD is optional and can be utilized by inserting
memory devices onto the board. Jumpers relevant to SSD configu-
ration are:
Number
J27 (1,2) SSD I/O address selection
J27 (3,4) SSD I/O address selection
J27 (5,6) SSD memory address selection
J27 (7,8) SSD memory address selection
J27 (9,10) SSD drive emulated
J27 (11,12) SSD drive emulated
J29 SSD harware enable/disable
J30 SSD ROM device selection
J31 SSD memory type selection
The PCM-4862 features an internal Flash/ROM disk drive. This
drive emulates a floppy disk drive by using solid-state memory
chips (Flash or EPROM) to store programs and data instead of the
magnetic particles on the mechanical drive's disk. The Flash/ROM
disk offers much faster access times than a floppy or hard disk and
greatly increased reliability in harsh environments.
IRQ15
Function
Chapter 2 Installation 27