Kohler 6EKOD Service Manual page 97

32. Install a sling capable of handling the weight of the
stator housing on the stator housing.
Figure 9-10.
1
3
1. Sling
2. Fan guard
3. Two-jaw puller
Figure 9-10 Stator Assembly Removal
33. Use a two-jaw puller to pull the end bracket/stator
assembly from the bearing on the rotor shaft. See
Figure 9-10.
34. Remove the stator assembly from the rotor.
Remove or rotate the fan guard, if necessary, to
clear the vibromounts.
35. Mark the fan's position on the rotor/drive disc
assembly with a permanent marker.
36. Remove the rotor/fan assembly from the engine
flywheel by removing the six nuts and stud. See
Figure 9-11.
37. Clamp the rotor in a soft-jaw vise. Remove the six
bolts and remove the drive disc assembly from the
rotor. See Figure 9-12.
TP-6774 2/14a
See
2
1. Bolts (6)
2. Rotor assembly
Figure 9-11 Rotor/Fan Assembly
558867
1
1. Rotor
2. Drive disc
3. Bolt
Figure 9-12 Drive Disc
Section 9 Generator Disassembly/Reassembly
1
GM73473-A
2
3
2
GM73473-A
97