Fuses - Kohler 6EKOD Service Manual

Marine generator sets
Hide thumbs Also See for 6EKOD:
Table of Contents

Advertisement

Coolant Temperature Sensor (CTS)
The coolant temperature sensor (CTS) is used to
monitor engine temperature for the high engine
temperature fault shutdown. See Figure 8-26 for the
coolant temperature sensor location. Power down the
generator set and allow the generator set to cool.
Disconnect the CTS and use an ohmmeter to measure
the resistance across the sensor.
resistance varies with temperature and should be within
the values shown in Figure 8-27. If the resistance is very
low (indicated a short circuit) or very high (indicating an
open circuit) replace the CTS.
1. Coolant temperature sensor
Figure 8-26 Coolant Temperature Sensor Location
Temperature, _C (_F)
30
(86)
100 (212)
Figure 8-27 Coolant Temperature Sensor Resistance
Readings (All Models)
High Exhaust Temperature (HET) Switch
In the event of a shutdown because of high exhaust
temperature, the ADC IId controller will display fault
code Exh. Temp High Shutdown. See Figure 8-28 for
the high exhaust temperature switch location. High
exhaust temperature of 215_ ±5_ F (102_ ±2.8_ C) will
cause the unit to shut down.
TP-6774 2/14a
The sensor
1
Resistance, Ohms
2106--2392
182--198
1. High exhaust temperature switch
Figure 8-28 High Exhaust Temperature Switch
Location

8.15 Fuses

Fuses are located on the side of the junction box. See
Figure 8-29. Always identify and correct the cause of a
blown fuse before restarting the generator set. Refer to
Section 6, Troubleshooting, for conditions that may
indicate a blown fuse.
identical replacement parts.
10-Amp (F1) fuse protects the auxiliary winding.
D
20-Amp (F2) fuse protects the controller circuits, fuel
D
pump, and fuel shutoff solenoid.
5-Amp (F3) fuse protects the customer connections.
D
1. Fuses (qty. 3)
Figure 8-29 Fuses on the Side of the Control Box
Fuse
Auxiliary Winding
Controller, Fuel Pump, and
Fuel Shutoff Solenoid
Customer Connection
Figure 8-30 Fuses
Section 8 Component Testing and Adjustment
1
Replace blown fuses with
1
Amps
Label
Part No.
10
F1
358337
20
F2
GM39266
5
F3
239298
89

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

9-11ekozd5efkod7-9efkozd

Table of Contents