Kohler 6EKOD Service Manual page 96

21. 9- -11EKOZD and 7- -9EFKOZD Models: Remove
the four screws to remove the exciter field. See
Figure 9-7.
1
2
1. Screws (4)
2. Exciter field
Figure 9-7 Exciter Field Removal
22. 9- -11EKOZD and 7- -9EFKOZD Models: Remove
the three screws and spacers from the rectifier
board.
23. 9- -11EKOZD and
Disconnect the main field rotor leads from the
rectifier board
Remove the armature retaining bolt and washer.
See Figure 9-8.
24. 9- -11EKOZD and 7- -9EFKOZD Models: Remove
the armature from the shaft, guiding the rotor leads
through the armature bores. See Figure 9-8.
1
1. Armature
2. Armature retaining bolt
3. Rotor leads
4. Rectifier board
Figure 9-8 Armature Removal
96 Section 9 Generator Disassembly/Reassembly
GM73474-A
7- -9EFKOZD Models:
positive/negative terminals.
2
3
4
25. 6EKOD/5EFKOD Model:
screws to remove the brush holder cover and brush
cover gasket.
26. 6EKOD/5EFKOD Model: Push the brushes into
the holder. Secure the brushes into position by
sliding a retainer into the brush keeping holder.
See Section 8.6.
27. 6EKOD/5EFKOD Model:
holder and carefully pull the leads out of the stator
housing.
28. Attach a hoist hook to the generator lifting eye. See
Figure 9-9.
Note: The hoist capacity rating should be one-half
ton or greater.
29. Remove the two vibromount bolts. See Figure 9-9.
30. Raise the alternator end and place a wood block
under the locator plate. Lower the alternator until
the wood block supports the backplate.
Figure 9-9.
31. Remove the four overbolts from the end bracket.
4
1. Lifting eye
2. Backplate
3. Wood block
4. Vibromounts
Figure 9-9 Supporting the Generator, Typical
558865
Remove the four
Remove the brush
1
2
3
See
558866
TP-6774 2/14a