ETC Desire D60 User Manual page 75

R e c a l i b r at e F ix t u r e
Service technicians may use this option to calibrate the constant current driver electronics
for the LEDs. The calibration process goes through each series of LEDs, starting at 0
intensity and stepping up to 100%. The calibration is automatic and takes a few minutes.
During this time, do not exit the screen until it is complete.
C A U T I O N :
Step 1:
Step 2:
Step 3:
Recalibrate Fixture
This Will Calibrate
Figure-4.36 LED Calibration Screen with Calibration in Process.
Step 4:
A b o u t F i x t u r e
The About screen displays the following information. This is a read-only screen.
• The software version number
• The fixture serial number
• The assigned fixture RDM number
• The color bias of the LED array
DMX START: 001
Ver: 1.4.1.0.0.20 (1)
Ser: 000021xxx
RDM: 6574:12345678
Desire Vivid 22
RDM Label
Figure-4.37 About Fixture Screen.
Step 1:
Step 2:
Step 3:
4
Operation
This calibration process does not measure or recalibrate the light output of the
LEDs.
Under normal use, it is not necessary to recalibrate the fixture, and doing so will
likely have no beneficial effect on fixture performance. It is therefore NOT
recommended to recalibrate the fixture without express instruction from an
authorized technician.
On the Diagnostics screen, scroll to ReCalibrate Fixture.
Press [Enter].
When asked if you are sure, select Yes and press [Enter].
A new screen shows that the calibration is in progress and whether the LEDs
pass the calibration.
Diagnostics
LED Array
Are You Sure?
Yes
No
Press [Enter] or [Back] to return to the Diagnostics screen.
About Fixture
On the Diagnostics screen, scroll to About Fixture.
Press [Enter].
Press [Enter] or [Back] to return to the Diagnostics screen.
LED Calibration
LED 1 .......Pass
LED 2 .......Pass
LED 3 .......Pass
LED 4 .......Working
LED 5 .......Working
LED 6 .......Working
LED 7 .......Working
69