Auto Answer; Caller Id Blocking - Vertical Edge 5000 Installation/Configuration Instructions

Auto Answer

Auto Answer
When idle, the IP Phone can connect an incoming caller to the speakerphone or headset
automatically.
To enable/disable Auto Answer:
• Press the Settings (
procedure. Refer to
• Press the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the digit, or move the cursor to 6.Auto Answer using the [Next]-[Previous]
softkeys and press the [OK] softkey.
• Press the [Yes] softkey to enable Auto Answer, or press the [No] softkey to disable
Auto Answer.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings (

Caller ID Blocking

The IP Phone normally sends the assigned display name as the SIP caller id for outgoing calls.
Optionally, the IP Phone can send "anonymous" as the caller id in SIP message headers.
To enable/disable blocking of caller id:
• Press the Settings (
procedure. Refer to
• Press the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the
[Next]-[Previous] softkeys and press the [OK] softkey.
• Press the [Yes] softkey to enable blocking of outgoing caller id, or press the [No]
softkey to disable blocking of outgoing caller id.
• Move to another parameter with the navigation buttons and continue the session or
press the Settings (
Release 1.0
) button. If the LCD Menu is locked, use the unlock
.
page 3-4
digit, or move the cursor to 4.Call Preferences using the
) button to exit the configuration session.
) button. If the LCD Menu is locked, use the unlock
.
page 3-4
digit, or move the cursor to 4.Call Preferences using the
digit, or move the cursor to 7.Caller ID Blocking using the
) button to exit the configuration session.
Edge 5000 Installation / Configuration Guide
Chapter 3: Using the LCD Configuration Menu
3-49
September 2010