Navigating The Lcd Configuration Menu; Entering Values With The Dial Pad And Softkeys - Vertical Edge 5000 Installation/Configuration Instructions

Navigating the LCD Configuration Menu

Navigating the LCD Configuration Menu
The IP phone must be idle to access the configuration menu and may be password protected
(Locked). If locked, advanced configuration parameters can be viewed, however, data entry is
not possible. Refer to "Lock/Unlock Configuration" on
To access the configuration menu:
Press the Settings (
To select an item:
Dial the digit associated with the menu item,
OR
Use the [Next]-[Previous] softkeys to move the cursor to the item, then press the [OK]
softkey.
The bottom line of the display shows three (3) softkey functions at a time. Additional softkey
functions are available when the right arrow,
Use the right navigation button,
To return to a previous branch in the menu when the return arrow,
left corner of the LCD:
Press the left navigation button,
To exit the configuration menu:
Press the Settings (

Entering Values with the Dial Pad and Softkeys

Use the dial pad to input numbers, letters, special characters, and a period. The [Mode] softkey
displays to indicate a parameter can accept an alphanumeric entry. Selecting the [Mode]
softkey switches the dial pad mode. The dial pad mode displays in the upper-right corner as
for numeric,
defines the relationship between the dial pad digits and characters.
Appendix E
To enter characters with the dial pad, use the digit with the desired character. Press the same
digit repeatedly until the desired character appears in the LCD. After entering a character,
pause to allow the cursor to move to next character position.
Release 1.0
) button.
, to view the additional softkeys.
.
) button.
for upper case characters and
Edge 5000 Installation / Configuration Guide
Chapter 3: Using the LCD Configuration Menu
page 3-4.
, appears in the bottom-right corner of the LCD.
for lower case characters.
3-3
, appears in the bottom
September 2010