Power Supplies - Brocade Communications Systems FWS648G-POE Hardware Installation Manual

1
Hardware features
FIGURE 8
2 System status LEDs
TABLE 3
LED
Power
Stack
RPS
POE

Power supplies

Optional redundant power supply
FWS devices support an optional redundant power supply (RPS), that can provide power to the
switch in the event the internal power supply fails.
Power supply receptacles
There are two power receptacles on the rear panel of each switch. The standard power receptacle
is for the AC power cord. The receptacle labeled "RPS" is for the optional redundant power supply
cord.
6
DRAFT: BROCADE CONFIDENTIAL
System status LEDs
System status LEDs
Condition
Green
Amber
Off
Off
Green
Amber
Green
Amber
Off
Green
Amber
Off
2
Status
Internal power is operating normally.
Internal power supply fault.
Power off or failure.
System stand alone
System in stacking master mode
System in stacking slave mode
Redundant power supply is providing power.
Primary power supply is active, RPS is on standby.
Redundant power supply is off or not plugged in.
POE module is operating normally.
POE module fault.
POE module not present.
Brocade FastIron WS Hardware Installation Guide
53-1002188-01