Operation - Rinnai FS 35 Operating And Installation Instructions

For your convenience the controls on your new Flame Fire are situated under the cover
on the top right-hand side of the heater.
All necessary adjustments to the operation of your heater can be made with these controls.
IGNITION
•
Press the front control button fi rmly. This operates the built-in
safety device and starts the electronic spark. The centre burner
will ignite. Check that the burner has lit and continue to hold the
button down for up to 15 seconds. The spark will continue while
the button is held down.
If the burner does not remain alight, push the button again and
release it. This will return it to the "OFF" position. Wait 30
seconds, then repeat the ignition procedure.
(The ignition button must be in the "OFF" position before attempt-
ing re-ignition).
TO INCREASE THE HEAT
•
Press the control buttons in order from front to rear, this will ignite additional burners as
shown in the diagram.
There is no need to hold the buttons for 15 seconds when increasing the heat.
SETTING INPUT
1. Ignition/Low 16 MJ/h
2. Medium 24 MJ/h
3. High
TO DECREASE THE HEAT
•
This is simply done by releasing the control buttons in order from rear to front.
TO TURN THE UNIT OFF
•
Press and release the buttons in order from back to front until all 3 buttons are in the "OFF"
(UP) position. The fan will continue to operate until the heater cools off.
Ensure all burners are extinguished.
FAN OPERATION
•
On the LOW and MEDIUM heater settings, the fan can be operated on the LOW speed or
OFF.
NOTE:
When the heater is turned on, there will be a delay in the operation of the fan. This
ensures that a cold draft does not occur while the heater is warming up.
When the heater is turned off, the fan will continue to run until the heater has cooled down.
POWER FAILURE
•
Your Rinnai Flame Fire can be used on the low and medium settings during a power failure.
However, if switched off, it cannot be relit unless power is available.
The appliance is protected by an overheat switch, and may cut out if used on the HIGH setting

OPERATION

BUTTONS
35 MJ/h
FAN
High / Off / Low
High / Off / Low
High (Auto)
3
BURNER PATTERN
.