Dual Image Status Page - HP 1810-24G Management And Configuration Manual

Table 9 Green Features Status fields
Field
Auto Port Power-Down
Low-Traffic Idle (EEE)
Cable Length Detect
LED Intensity
Intensity Level
Start Time
Duration
Recur Daily
Interface
Link Partner Supports EEE
Wakeup Time Negotiated by LLDP
Rx Wakeup Time (μSec)
Tx Wakeup Time (μSec)

Dual Image Status page

The Dual Image Status page displays the status of the two software images (image1 and image2)
on the switch. It also provides details about the current active and alternate images, and software
image versions.
To display the Dual Image page, click Status > Dual Image in the navigation bar.
As shown in Figure
a reboot.
22 Status Pages
Description
Port Energy Saving Configuration
The current Auto Port Power-Down setting (Enabled or Disabled). When
enabled, the port is set in power save mode when there is no link.
The current Energy Efficient Ethernet (EEE) setting (Enabled or Disabled).
When enabled, ports that are not passing traffic are powered off until the
link partner indicates the port should power on to receive new data.
Cable Energy Saving Configuration
The current Cable Length Detect setting (Enabled or Disabled). When
enabled, port power consumption is adjusted based upon cable length.
Short cables use less power than long cables.
LED Intensity Configuration
The setting (Enabled or Disabled) that indicates if the switch is configured
to change LED intensity levels at certain times of day.
The desired LED intensity level that takes effect if the LED Intensity setting is
enabled. Valid values are High, Medium, Low, or Off. Default value is Off.
The time of day when the configured LED Intensity Level is activated.
The number of hours the configured LED Intensity Level is in effect.
The current setting (Yes or No) that indicates if the LED intensity levels will
change daily at the configured time.
EEE Interface Status
The port number.
Indicates if the link partner supports EEE (Yes or No).
Indicates if the EEE wakeup time is negotiated with the link partner (Yes or
No). If No, the Rx Wakeup time and Tx Wakeup time columns display a
dash.
The Rx Wakeup time in effect for that port.
The Tx Wakeup time in effect for that port.
13, Image1 is the active image and will continue to be the active image after