System Leds; Port Leds - HP 1810-24G Management And Configuration Manual

System LEDs

Point to the System LEDs area to view information about the following LEDs:
Power (Green)
◦
On—The switch is receiving power.
◦
Off—The switch is NOT receiving power.
Fault (Orange)
◦
Blinking—A fault has occurred, other than during self-test.
◦
On—Self-test in progress.
◦
Off—The switch is operating properly.
Locator (Blue)
◦
Blinking—The switch is in Locate mode, attempting to locate a specific switch.
◦
Off—The locator is disabled. This mode can be enabled using the Web interface. See
"Locator" (page

Port LEDs

Each 10/100/1000 Mbps RJ45 port has two single color LEDs to indicate the, Link/Activity on
the Left port LED and the Speed status indicated by the Right port LED.
The left-port LED indicates link status, as follows:
On—The port is enabled and receiving a link indication or other signal from the connected
device.
Blinking—The port has network activity.
Off—The port has no active network cable connected, is not receiving link signal, or is disabled.
The right-port LED indicates speed status, as follows:
On—The port is operating continuously at 1000 Mbps.
Blinking—The port is operating at 100 Mbps.
Off—The port is operating at 10 Mbps.
NOTE: The PD LEDs on the HP1810-8G glow when the switch is powered via the PD Port 1 using
an external PoE device.
57).
Getting started with the web interface 1 1