Dual Image Configuration - HP 1810-24G Management And Configuration Manual

Figure 48 Password Manager Page
NOTE: There is no default password. Passwords must be at least 8 characters but no more than
64 characters long. Passwords are case sensitive. There is no default password. Passwords are
up to 64 alpha-numeric and special characters
(~,`,!,@,#,$,%,^,&,*,(,),-,_,+,=,{,[,},],|,\,<,,,>,.,?,/",' and space) in length, and are case sensitive.
The password needs to be entered again to confirm new password. In case of a forgotten password,
manually reset the switch to its factory defaults.
Enter the old password and the new password twice, and click Apply. At the next log on, use the
new password.

Dual Image Configuration

Use the Dual Image Configuration page to name and change the next bootup image. The Dual
Image Configuration allows activating either of the stored images: Image1 or Image2. When one
image is activated, the other image serves as a backup; if Image1 either fails or does not boot,
then the other image can be activated.
To display the Dual Image Configuration page, click Maintenance > Dual Image Configuration.
Figure 49 Dual Image Configuration Page
Table 37 Dual Image Configuration Fields
Field
Image Name
Active Image
Image Description
Image Version
Click Activate to activate the selected image selected in the Image Name field. Be sure to
configure the Image Description field to the version of the image loaded so that users can
easily distinguish between the images.
Click Apply to apply a description to the image selected in the Image Name field.
Click Delete to delete the image selected in the Image Name field.
Description
Select the image you want to perform an action on. You can activate the selected image,
delete it, or configure a description of it. Options are Image1 and Image2.
The currently active image.
Specify a description of the image selected in the Image Name field.
The software version associated with the active image.
Dual Image Configuration 65