8
Gently push the saddle stitcher unit (F-C5) back into the machine, and close the front cover.
1
Removing Punch Waste
When the punch waste tray of the Puncher Unit-BF1 becomes full, a screen prompting you to remove the punch waste appears on
the touch panel display. Follow the procedure described below to remove the punch waste.
Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to replace a staple
cartridge, discard the punch waste, discard the trim waste, or clear paper or staple jams, prints may still be output if other optional units are
operating normally, and are not involved in the paper or staple jam removal procedure.
•
This procedure is necessary only if the Puncher Unit-BF1 is attached.
•
When the punch waste tray is full, you cannot make copies or prints using the Hole Punch mode.
1
Open the front cover of the finisher.
1-50
Staple Finisher-D1/Booklet Finisher-D1/Puncher Unit-BF1/Inner Booklet Trimmer-A1 (Optional)
1. Gently push the saddle stitcher unit (F-C5) back into the
machine.
Always make sure to push the saddle sticher unit in as far as it can go.
2. Close the front cover of the finisher.