Operating The Limited Functions Mode - Canon imageRUNNER ADVANCE 8085 Maintenance Manual

Operating the Limited Functions Mode

If a specific message (the service call message) appears on the display, operate the Limited Functions Mode. When the Limited
Functions Mode is set to 'On' and make the corresponding function stop its operation, the other functions may be able to perform
normally.
Call your service representative before you operate the module separation switch.
1
The following is a list of self-diagnostic error messages, along with their possible causes and remedies.
E503h, E5A4h, E5AAh, E5A3h, E5BAh, E5BBh, E5F0h, E5F1h, E5F2h, E5F3h, E5F4h, E5F5h, E5F6h, E5F7h, E5F8h, E5F9h
Cause The saddle stitcher unit (or the booklet trimmer) is out of order.
Remedy You can make copies/prints using functions other than the Saddle Stitch or Trim mode by operating the Limited Functions Mode.
E514h, E530h, E531h, E532h, E537h, E540h, E542h, E568h, E56Dh, E578h, E57Bh, E57Ch, E583h, E584h
Cause Tray A/B/C is out of order.
Remedy You can make copies/prints by operating the Limited Functions Mode and fixing the tray position.
E518h, E562h, E569h, E56Ah, E56Bh, E56Eh
Cause The Folding Unit is out of order.
Remedy You can make copies/prints without using the folding mode by operating the Limited Functions Mode.
E590h, E591h, E592h, E593h
Cause The Puncher Unit-BF1 is out of order.
Remedy You can make copies/prints using functions other than the hole punch function by operating the Limited Functions Mode.
After setting the Limited Functions Mode to 'On' , the corresponding function will be grayed out on the display, and cannot be used.
1
Press
Functions Mode].
For instructions on setting the Limited Functions Mode from the Service Call Message screen, see "Setting the Limited Functions Mode
from the Service Call Message Screen, " on p. 2-89.
1-52 Staple Finisher-D1/Booklet Finisher-D1/Puncher Unit-BF1/Inner Booklet Trimmer-A1 (Optional)
(Settings/Registration)→ [Management Settings] → [Device Management] → [Limited