List Of Error Messages; Self-Diagnostic Display - Canon imageRUNNER ADVANCE 8085 Maintenance Manual

List of Error Messages

This section explains the various messages that appear on the touch panel display, along with possible causes and remedies.
For explanations of messages that are not listed here, see e-Manual > Optional Products/Software, Scan and Send, Quick Menu,
Network, MEAP, and Security.

Self-Diagnostic Display

If the machine displays a self-diagnostic error message, follow the instructions on the touch panel display.
Self-diagnostic error messages appear on the touch panel display at the following times:
•
When scanning or printing cannot be performed because of an operational error.
•
When you need to make a decision or take some action during scanning, copying, or printing.
•
When you need to make a decision or take some action while browsing the network.
The following is a list of self-diagnostic error messages, along with their possible causes and remedies.
Load paper.
Cause 1 The machine has run out of paper. No more prints can be made.
Remedy Load paper. (See "Loading Paper, " on p. 1-3.)
Cause 2 The paper drawer is not correctly inserted.
Remedy Insert the paper drawer as far as it will go. (See "Loading Paper, " on p. 1-3.)
Load LTR size paper.
Cause 1 The optimum paper size selected by the Automatic Paper Selection mode is not available in the machine.
Remedy Load the indicated paper size into the machine.
Cause 2 [Paper Drawer Auto Selection On/Off ] is set to 'Off' .
Remedy 1 Manually specify the paper drawer.
Remedy 2 Set [Paper Drawer Auto Selection On/Off ] to 'On' for the paper drawer in which the displayed paper size is loaded. (See e-Manual >
Settings/Registration.)
Cause 3 A paper type not supported by automatic paper selection is loaded.
Remedy 1 Manually specify the paper drawer.
Remedy 2 Set [Consider Paper Type] in [Paper Drawer Auto Selection On/Off ] to 'Off' when copying. (See e-Manual > Settings/Registration.)
Return page 1 to the top, and then press the [Start] key.
Cause Scanning was stopped due to a problem with the feeder.
Remedy Arrange the originals in page order with the first page on top. Place the originals back into the feeder's original supply tray, and
press (Start).
Return page 1 to the top, and then press the [Start] key. (Data for the scanned original has exceeded limits on the size that can be handled by
this machine. Automatically adjust settings and try again.)
Cause Scanning has stopped because the data size of the scanned original exceeds the maximum data size that the machine can handle.
Remedy Try scanning the original again from the first page. If scanning is still not possible, reduce the Sharpness mode setting, and select
[Text] for the original type.

List of Error Messages

2-73
2