Canon imageRUNNER ADVANCE 8085 Maintenance Manual page 30

4
Load the paper stack into the paper deck.
Make sure that the inside lifter has lowered before loading paper, and even out the edges of the paper stack, and stack the paper neatly
against the inner paper guide.
1
•
Do not load paper into the paper deck that has been previously printed on, as this may result in a malfunction or damage to the
machine. Always use the Multi-Purpose Tray to feed paper when you want to print on the back of a sheet of paper that already has
something printed its front side (2nd side of 2-Sided copy).
•
Make sure that the size change plate in the POD Deck Lite is properly aligned with the marks of the desired paper size. If the size change
plate is not properly aligned, the POD Deck Lite may become damaged.
•
Make sure that the height of the paper stack does not exceed the loading limit mark (
•
Load the paper stack in stages in Paper Deck Unit/POD Deck Lite, adding approximately 550 sheets of paper (20 lb bond (80 g/m
time. If the paper deck can accommodate more paper, the lifter will descend.
•
For more information on aligning the size change plate, see "Changing the Paper Size for the POD Deck Lite, " on p. 1-19.
•
Hot air that is blown by the fan may warm the inner size change plate of the POD Deck Lite.
•
When paper is loaded in the paper deck, the side facing up is the one printed on.
5
Lower the feeding support roller, and close the paper deck.
1-18 Paper Deck Unit-C1/POD Deck Lite-A1 (Optional)
) on the inside of the paper deck.
1. Lower the feeding support roller. (This procedure is not
necessary for the Paper Deck Unit.)
2. Gently push the paper deck back into the machine until it
clicks into place in the closed position.
The inside lifter automatically rises, and prepares the paper deck for
feeding.
2
)) at a