Replacing The Staple Cartridge In The Saddle Stitcher Unit - Canon imageRUNNER ADVANCE 8085 Maintenance Manual

Replacing the Staple Cartridge in the Saddle Stitcher Unit

When the saddle stitcher unit of the Booklet Finisher-F1 PRO is out of staples, and the staple cartridge must be replaced, a screen
similar to the one shown below appears on the touch panel display.
Follow the procedure described below to replace the staple cartridge.
Use only staple cartridges intended for use in this machine.
•
Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to replace a staple
cartridge, discard the punch waste, or clear paper or staple jams, prints may still be output if other optional units are operating normally, and
are not involved in the paper or staple jam removal procedure.
•
If necessary, remove all of the output paper in the Booklet Tray before replacing the staple cartridge in the saddle stitcher unit.
•
This procedure is necessary only if the Booklet Finisher-F1 PRO is attached.
•
When replacing the staple cartridges, replace both the front and back staple cartridges.
•
Since both the front and inner staple cartridges need to be replaced when staples run out in the saddle stitcher unit, we recommend that you
order staple cartridges from your local authorized Canon dealer before your stock runs out.
1
Open the front cover of the finisher.
Staple Finisher-F1 PRO/Booklet Finisher-F1 PRO/Puncher Unit-BB1/Booklet Trimmer-D1 (Optional)
1
1-33