Connecting To Your Computer Network - Roberts R100 Manual

This section of this book describes how to connect the radio to your network using either the wireless (WiFi)
connection or the wired (Ethernet) connection.
Before you can use your R100 radio to listen to Internet radio or to music streamed from your computer, it must
These instructions also apply to the Network Wizard in the Network Settings menu (from step 2 onwards).The
following instructions assume t
described on the preceding page.
1. After setting the Daylight Savings options (see page 9), the display will show the 'Keep network connected?'
'Yes' if you wish to keep the radio connected to the network when it is in Standby
'Yes' if using your radio as part of a group of multi-room products.
If you choose 'No' then your radio will shut down its WiFi or Ethernet connection except when using internet
radio, Spotify and music player modes. This minimises power consumption but it does mean that you will
need to switch the radio on manually in order to use either Spotify Connect, the 'Play to' / 'Cast to Device'
function or any remote control software such as the UNDOK app.
Press the Tuning Up or Down buttons to highlight the required option and then press the Select button to
make the selection.
After setting the Keep Connected option, the display will show a list of supported WiFi regional options.
Press the Tuning Up or Down buttons to highlight the required region (for the UK choose 'Europe'), and then
press the Select button to make the selection. Do this even if you are planning to use the wired Ethernet
2. The radio will enter the Network Settings Wizard and will display 'Scanning...'. The radio will automatically
scan both 2.4GHz and 5GHz WiFi bands. After a short while the display will show a list of the available WiFi
networks. If you are intending to use the WiFi connection, go to step 3 on the next page.
buttons to point to the '[Wired]' menu item. Press the Select button and the radio will attempt to connect.
The screen should say 'Connecting...', and then 'Setup wizard completed'. Press the Select button to exit
Network settings
Keep network connected?
Wlan region
Europe
Network settings
SSID
[WPS]Smith
Jones
Paul's network
[Rescan]
[Wired]
[Manual config]
Please wait
Tuning Up or Down
*
Network wizard
Scanning...
Waiting for
Ethernet
10