Roberts R100 Manual page 14

There are two indicator lights incorporated into the RJ-45 connector. If you
have problems with your wired connection, they may help you to identify the
possible cause of the problem.
Green ON = Link established; OFF = no connection
it up manually then you should select
'[Wired]' in the Network Wizard, then go to page 107.
in the list of network names presented by the Network Wizard. If no networks
are found then you may have to get your wireless router working (please see
the instructions supplied with it) or you may be too far from the router.
for the wireless access point on the screen. This is a name that is allocated
to the access point in your router by the person who set up the network - for
example: 'Jones family' or 'Paul's network'. Routers supplied by Internet Service
Providers often have the default name of the WiFi network provided on a label
or card for easy reference (e.g. BTHub - 1234, virginmedia 1234567). If the
router supports WiFi Protected Setup, then '[WPS]' will be shown in front of
the SSID.
than one wireless network, in which case you should choose which one you
need to connect to.
4. Press the Tuning Up or Down buttons to see the SSID for each wireless
network that has been found. If your network is shown proceed to step 6 on
the next page. If it is not shown then proceed to step 5, also on the next page.
If you make a mistake at any point, use the Back button to go back to the
previous screen.
11
instead of selecting
Setup wizard
3,4
Main menu
3,4
Internet radio
Spotify
Music player
DAB
FM
Bluetooth
Network settings
SSID
Jones family
[WPS] Paul's network
Smith
Back
[Rescan]
[Wired]
[Manual config]
Setup wizard
completed
Press 'SELECT' to exit
Network wizard
Scanning...