Connecting To Your Computer Network - Roberts Stream 94L Manual

Connecting to your computer network

Before you can use your Stream 94L radio to listen to Internet radio, it must first be connected to your computer
network.
This section of this book describes how to connect the radio to your network using the wireless (WiFi) connection.
The following instructions assume that you have just set up the clock and time options using the Setup Wizard
as described on the preceding page.
These instructions also apply to the Network Wizard in the Network Settings menu (from step 2 onwards).
1. After setting the Daylight Savings options (see page 10), the display will show the 'Keep network connected?'
option. You should choose 'Yes' if you wish to keep the radio connected to the network when it is in Standby
mode. This will allow remote control software to switch on your radio when needed.
If you choose 'No' then your radio will shut down its WiFi connection when it is in Standby, DAB, FM, Bluetooth
or Aux-in modes. This minimises power consumption but it does mean that you will need to switch the radio
on manually in order to use either Streaming Services or any remote control software such as the UNDOK
app.
Rotate Tuning to highlight the required option and then press the control to make the selection.
Your radio will then scan for available WiFi networks.
2. The radio will enter the Network Settings Wizard and will display 'Scanning...'. The radio will automatically
scan both 2.4GHz and 5GHz WiFi bands. After a short while the display will show a list of the available WiFi
networks. Setup using the WiFi connection, go to step 3 on the next page.
11
60
DAB
Network Settings
Keep network connected?
*
Network Settings
Network Wizard
Scanning...