Agilent Technologies 5975 Operation Manual page 58

3
Operating in Electron Impact (EI) Mode
Table 7
Action
Prepare to vent
Pumpdown
Table 8
Action
High Vacuum Pressure
Turbo Pump Speed
Foreline Pressure
MSD Fault Status
Ion Source Temp,
Mass Filter Temp,
CI Reagent
MS parameters cannot be set from the LCP while an online MassHunter Data Acquisition
NO T E
session is connected to the MSD.
Table 9
Action
MSD IP via BootP
Gateway IP Address
Subnet Mask
ChemStation IP
GC IP Address
Ping gateway
58
Maintenance menu
Description
Reminds you to shut down the GC then prepares the instrument for
venting when [Yes/Select] is pressed.
Initiates a pumpdown sequence.
MS Parameters menu
Description
Only with Micro-Ion vacuum gauge installed.
Displays the turbo pump speed.
Displays the foreline pressure.
Reports a summary fault status code (number) in 'dec' (decimal) and
'hex' (hexadecimal) format covering all possible fault combinations.
o
C Displays and sets the ion source temperature.
o
C Displays and sets the mass filter temperature.
Displays CI reagent gas and flow rate (if installed).
Network menu
Description
Displays the IP address for the MSD.
Displays the gateway IP address for the MSD.
Displays the subnet mask for the MSD.
Displays the IP address for the MassHunter Data Acquisition.
Displays the IP address for the GC.
Checks communication with the gateway.
5975 Series MSD Operation Manual for MassHunter