Stringing The Frame - Gamma 6900 Els Owner's Manual

for reduced clamping pressure while securing and holding the string under tension.
MOUNTING THE FRAME

STRINGING THE FRAME

Frame Support Slide Adjustment
The Frame Support Slide need only be adjusted
if the shoulder supports are blocking a grommet
hole. Do not extend the Frame Support Slide
beyond the machined line located on the Sup-
port Slide.
Apply a final adjustment to all racquet support
points until the racquet is firmly secured in the
mounting system.
Should the frame supports lose contact with
the frame while stringing, they should be re-
adjusted, as needed, to maintain contact with
the Racquet frame.
String Clamp Operation
The string clamps are a dual action design
where the string clamp and clamp base oper-
ate independently of one another.
To clamp a string, lift the string clamp, place
the string between the jaws and depress the
string clamp lever to secure the string. The
clamping pressure applied to the string should
be adjusted to provide sufficient pressure
to secure the string when subjected to the
desired pulling tension. The diamond coated
gripper plates provide for increased friction
between the clamps and the string to allow
Clamp Base Operation
To lock the string clamp base to the turntable,
rotate the clamp base locking lever clock-
wise. To release the string clamp base from
the turntable, rotate the clamp base locking
lever counter-clockwise.
The Locking Lever should be tightened
enough to prevent clamp base slippage on
the turntable when the desired tension is
placed on the string.
13