Gamma 6900 Els Owner's Manual page 6

ASSEMBLY INSTRUCTIONS
Floor Stand Assembly
The stringing machine uses a four leg floor
stand design. The legs must be assembled
to the lower column before use. Remove
all parts from the shipping carton to con-
firm that contents match the list of parts on
Page 5.
Floor Stand Leg Assembly
Align the holes in the leg flange with
the matching holes in the lower column.
Secure the leg with one M8 FLAT HEAD
screw through the upper hole, and one M8
SOCKET HEAD cap screw through the
bottom hole. Install one 8mm nut on each
screw. Repeat this procedure for the three
remaining legs.
Floor Stand Assembly (Continued.)
To complete the floor stand, screw the height adjust-
ment locking knob ("A") into the side of the lower
column. The locking knob should not protrude beyond
the inside surface of the lower column at this time.
6