Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Remove this Screw
Height Adjustment
The height of the machine is adjustable
from 39" to 46" in approximate 1" incre-
ments. To change the height, remove the
socket head cap screw from its current
position and place it in the appropriate hole
to set the desired height of the machine.
Be sure to thread the screw completely
into the upper column so the head of the
cap screw rests in the notch of the lower
column.
Stand Upper Post Installation
With the height adjustment cap screw on
the upper column facing the string reel
holder, align the four holes in the upper
column flange with the threaded holes in
the machine base. Lift the machine base
and insert the upper post into the lower
column until the head of the cap screw
rests in the notch of the lower column and
tighten the locking knob.
Transportation Screw
The machine has been shipped with a motor
and load cell protection screw. Remove the
screw before using the machine. Retain the
screw for future shipment. Install the included
rubber grommet into the hole.
7
Hide quick links:
Advertisement
Table of Contents
