Stringing The Frame - Gamma Progression STII Owner's Manual

tension by 1 or 2 lbs turn the knob counterclockwise until the "1" or "2" mark on the knob aligns
with the line on the knob support. To decrease tension by 1 or 2 lbs, turn the knob clockwise
until the "2" or "1" mark on the knob aligns with the line on the knob support.

STRINGING THE FRAME

Travel Stop
Setting Tension
The STII utilizes a rotary adjusting knob
along with a linear tension scale to indicate
the tension setting. The scale is divided into
3 lb increments and each 1/3 turn of the
tension knob changes tension by 1 lb. To set
the desired tension, rotate the tension knob
and align the mark on the spring guide with
the desired tension setting on the scale.
When the "0" mark on the knob aligns with
the line on the knob support the tension will
be that indicated on the scale. To increase
Tensioner Travel Stop
The tensioner bar is equipped with a
tensioner travel stop to limit travel of the
tensioner along the bar and prevent contact
between the tensioner and the racquet
mounting system while stringing. The travel
stop is located about midpoint along the
tensioner bar below the gear track.
To disengage the stop, pull and hold the
knob, rotate 90 degrees and release. To
engage the stop, repeat the above proce-
dure until the travel stop pin protrudes be-
yond the opposite surface of the tensioner
bar.
Setting the Gripper Jaw Spacing
The gripper jaws of the tensioner are adjust-
able to accomodate varying string gauges.
If the string slips through the gripper jaws
while pulling tension, rotate the gripper jaw
adjustment screw counter-clockwise.
If the string is damaged while pulling tension,
rotate the gripper jaw adjustment screw clock-
wise.
The jaws will be properly adjusted when
there is enough pressure to securely grip the
string without causing damage to the string.
7