Gamma 6900 Els Owner's Manual page 11

CONTROL PANEL FUNCTIONS
AND FEATURES
Tension Index Buttons - Changes
tension setting in +/- 1.0 or +/- 0.1 Lb or
Kg increments. Holding the button down
will scroll the tension setting values up
or down. Tension settings entered with
the tension index buttons are placed into
temporary memory setting "0".
Clear Button - Clears display to enter
a new tension or to reset String Length
Meter measurement.
Test Button & Racquet Strung -
Press once for approximate number of
racquets strung. Press again to return.
Press and hold for 5 seconds and the
machine does an internal diagnostic
check, such as the one performed at
start-up.
Lbs/Kgs Button - Changes tension dis-
play from Lbs to Kgs. Each press of the
button toggles back and forth between
Lbs and Kgs.
Pre-Stretch Function - Pulls string 10%
or 20% over the tension setting (up to
90 lbs / 40.8 kgs), releases the string
and re-pulls to the tension setting. Each
press of the button toggles between
10%, 20% or no pre-stretch.
Single Digit (1-9)
Memory LED Display
Memory Button - Indexes from 9 pre-
set tension settings that can be stored
in memory. Settings are retained even
if machine is turned off. Each press of
the button indexes to the next memory
setting. Memory settings 1-9 must be
entered using the keypad followed by
pressing the "ENT" button.
Enter Button - Saves displayed
tension for Memory setting - when
tension is entered using the keypad
display flashes until this button is
pressed to save the setting. Also
Clears display for String Length Meter
measurements.
Knot Function - Increases pulling
tension by 10% over the setting value
(max 90 lbs / 40.8 kgs) for one pull.
During the pull the LED stays lit to
indicate the Knot function is enabled.
Speed Button - Changes pulling
speed of winder from Fast (default)
to Medium to Slow. Slow speed is
recommended for low stretch strings,
such as Kevlar. Each press of the
button toggles between Fast, Medium
and Slow speeds.
String Length Meter Button- Enables
string length meter function. Each
press of the button toggles between
Meters and Feet. To switch back to
tensioning function, press the "Lbs/
Kgs" button.
11
Three Digit (XX.X)
Tension Setting Dis-
play or String Length
LED Display