CyberData VoIP Intercom 010935F Operation Manual page 42

Hide thumbs Also See for VoIP Intercom 010935F:

Table of Contents

4.2.5.2 Point-to-Point Configuration

When the board is set to not register with a SIP server (see

intercom to dial out to a single endpoint.

In this case, the dial-out extension should be the IP address of the remote device. The Intercom can

also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point

Mode.

Note

Operations Guide

Receiving point-to-point SiP calls may not work with all phones.

Figure 4-19. SIP Configuration Page Set to Point-to-Point Mode

Intercom is set to NOT register with a SiP server

930242M

Installing the VoIP Intercom

Figure

4-19), it's possible to set the

CyberData Corporation

Intercom Setup

Table of Contents

Need help?

Do you have a question about the VoIP Intercom 010935F and is the answer not in the manual?