Using The Remote Control Unit - Marantz CD-17mkIII User Manual

REAR
A A A A A
ANALOG OUTPUT jacks
Connect to the CD or AUX input jacks of a preamplifier.
B B B B B
DIGITAL OUTPUT OPTICAL output jack
The digital signal can transmitted in the form of light through an optical
fiber cable and photocoupler. The optical signal transmission features
low signal loss due to cables and complete isolation of the ground loop
so that the very high quality can be reproduced without any digital noise
Connection method:
Connect this jack to aD/A converter, digital sound processor or an
amplifier equipped with a Digital Optical input jack. Remove the caps
from the DIGITAL OUTPUT OPTICAL jack and the Optical input jack of
the connected component and connect the two jacks through an optical
fiber cable.
* Do not bend the optical fiber cable.
* Leave the cap attached when the OPTICAL jack is not used.
C C C C C
DIGITAL OUTPUT COAXIAL output jack
By connecting this jack to a digital audio component (D/A converter,
digital sound processor, etc.), digital signals from compact discs can be
transmitted directly from the player without first being converted to
analog.
D D D D D
REMOTE CONTROL IN/OUT jacks
By connecting this CD player to another Marantz audio component
using a D-BUS remote control cable, you can operate the components
remotely as a single system.
• When connecting to a component with a remote sensor, connect the
REMOTE CONTROL IN jack of this unit to the REMOTE CONTROL
OUT jack of the component with the remote sensor.
• When connecting to a component which is not equipped with a remote
sensor, connect the component to the REMOTE CONTROL OUT jack
of this unit.
For the D-BUS cable connection, use a commercially available RCA-
type pin lead.
• By connecting this CD player to a Marantz auto reverse cassette deck
(such as the SD4050), automatic recording from the CD player to the
cassette deck can be carried out.
E E E E E
REMOTE switch
When using this unit independently, set this switch to INTERNAL. When
using this unit in a system incorporating a Marantz tuner or timer
equipped with a remote sensor, set the switch to EXTERNAL.
NOTE
Always set this switch to INTERNAL unless the unit is connected with
other MARANTZ equipment through a system connection. When this
switch is set to EXTERNAL, the main unit cannot be controlled from
the provided remote control unit.
F F F F F
AC POWER INPUT jack
Using the provided AC cord, connect to a household AC power outlet.

USING THE REMOTE CONTROL UNIT

1. Remote control
Operate the remote control unit (RC-DA17CD) within a distance of
approx. 5 m from the infrared signal reception window (remote sensor)
on the front of the CD player.
Remote control operation may not be possible if the remote control unit's
transmitter is not pointing in the direction of the remote sensor or if there
is an obstruction between the transmitter and the remote sensor.
Remote control operating range
Approx. 5m
Remote control unit (RC-DA17CD)
2. Loading batteries
Batteries in this remote control unit have a life of approximately 1 year
under normal operating conditions. If the remote control unit is not going
to be used for an extended period of time, remove the batteries. Also, if
you notice that the batteries are starting to run down, replace them as
soon as possible.
q
Remove the battery cover.
w
Insert the batteries with correct +/– orientation.
e
Close the battery cover until it clicks shut.
5
CD player
60°
Remote control unit (RC-DA17CD)
Rear side
Two AAA-size (R03) batteries