LifeSpan SP-710 Owner's Manual page 17

OPERATION ORDER
1. Install 2 x 1.5V UM-4 or AAA batteries. The screen will display in accordance with
(Picture A) and "Beep" at the same time. It will then enter to standby mode (Picture B).
Picture A
2. Use the SET button to preset values for TIME/DISTANCE/CALORIES/PULSE. SET
alters the value for a specific category. MODE confirms a set value.
3. The values RPM/SPEED/TIME/DISTANCE/CALORIES/PULSE will start increasing as
soon as the sensor receives a signal that you are pedalling.
If preset values have been set, the monitor will 'beep' for 8 seconds once the function
counts down to 0. The function will then immediately count up from 0 if the workout is
continued. During this, press MODE to confirm and skip to the next set up option.
Picture B
17
SP-710