Tools Required; Installing A Second Hard Disk Drive (Drive Cage Mounted) - HP Tc2120 - Server - 256 MB RAM Maintenance Manual

Chapter 3
Mass Storage Devices
Table 3-1 lists the number and types of mass storage devices that may be added to the hp server.
Table 3-1. Mass Storage Devices
Device Type
FDD
CD-ROM
DVD
IDE Hard Disk Drive
IDE Hard Disk Drive IDE-1
SCSI Backup Tape
Drive**
SCSI Hard Disk
Drive
* The secondary IDE (IDE-2) cable is connected to the factory-installed CD-ROM drive. The primary IDE connector (IDE-1) is available
on the SCSI model.
** A 50-to-68-pin SCSI adapter is provided with the HP backup tape drive.

Tools Required

Use an anti-static service kit (3M 8501/8502/8503 or equivalent). This kit includes a static-dissipating work
surface, a chassis clip lead, and a wrist strap.

Installing a Second Hard Disk Drive (Drive Cage Mounted)

The first hard disk drive (IDE or SCSI) is always mounted in the top (shelf 5) of the hard disk drive cage. The
second hard disk drive should be mounted just below it (shelf 6).
1. If the server is already installed and operating, power down the server.
Refer to Chapter 1‚ Controls and
2. Disconnect the power cables and any external cables connected to the server.
If necessary, label each one to expedite re-assembly.
3. Remove the side cover from the server.
Refer to "Opening and Closing the hp server"
4. Press and release the retaining clips at the sides of the drive cage. See
Maximum
Interface Type Devices
1
IDE-2* 2
2
SCSI controller 1
board
Internal SCSI 4
cable (Ultra-
160 SCSI
Adapter)
Indicators.
Installed Devices and Addresses
• Factory installed flexible disk drive (FDD) in shelf 1
• Factory installed CD-ROM drive in shelf 2
• Optional IDE device (backup tape drive, CD-ROM,
DVD drive, or IDE hard drive) in shelf 3 or 4 (shelf
3 is recommended)
• Factory installed IDE hard drive in shelf 5
• Optional 2nd IDE hard drive in shelf 6
• Optional SCSI backup tape drive in shelf 3
(address = ID 3)
• Factory installed SCSI HDD (shelf 5, address = ID
0
• Optional 2nd SCSI HDD (shelf 6, addresses = ID 1).
• Optional 3rd SCSI HDD (shelf 4, address = ID 2)
• SCSI controller (address = ID 7)
earlier in this chapter.
Figure
Installing and Configuring
3-6.
20