Automatic Alignment; Automatic Closing; Autoclose Override - Centsys D3 User Manual

Automatic alignment

CENTSYS operators are fitted with a manual override mechanism. This is to allow the
gate to be operated in the event of a total malfunction of the equipment. It is also
required if the mains power has failed in the case of the 220V operators ( A10 models).
When a command signal is given after the gate has been moved manually and then re-
engaged, the gate will drive to either it's fully open, or closed, position. Referred to as
automatic alignment, the gate can only be stopped, but not reversed until the align-
ment cycle is complete. The system will then revert to normal operation.
Automatic closing (optional)
The system has the facility to automatically close the gate after it has been opened.
The default setting is that this facility is disabled. The time that the gate remains open
can be adjusted up to four minutes where the default is 15 seconds.

Autoclose override

The Autoclose function can be temporarily overridden by holding down the remote
control pushbutton or intercom gate release when opening the gate, until the gate
stops. (Default setting is three seconds. It can be changed to suit.) This confirms
that the Autoclose has been overridden. On releasing the button, the gate will
continue to open fully, and remain open as long as required.
INTERCOM PUSHBUTTON or REMOTE
PRESS and HOLD GATE RELEASE
FOR THREE SECONDS TO
OVERRIDE AUTOCLOSE
Closing the gate by using either the transmitter or intercom gate release button
resets the system back to Autoclose.
Page 11