Tilt Adjustment - Crestron TPMC-9 Operation Manual

Crestron TPMC-9
Operations Guide – DOC. 6965E
Hardware Connections for the TPS-6X-IMCW (Rear)
POWER:
From DC
Power Pack
VIDEO IN:
Balanced or
Unbalanced Source
NET:
To Control System
and Other Cresnet
Devices
NOTE: Ensure the TPS-6X-IMCW is properly grounded.
NOTE: To prevent overheating, do not operate this product in an area that exceeds
the environmental temperature range listed in the table of specifications.
NOTE: The TPS-6X-IMCW can be powered via the 24 VDC jack on either the
front or the back of the unit if the NET port is not being used to power the module.

Tilt Adjustment

The head of the TPMC-9 pedestal can be tilted 45 degrees from vertical. The tilt
angle must be set to a fixed position for normal use. The tilt mechanism can be
adjusted by loosening the tilt clutch using the 5/32" hex wrench included with the
touch screen. Adjust to desired tilt angle, then lock the mechanism by tightening the
tilt clutch. Refer to the illustration below.
Touch Screen Tilt Clutch Adjustment
9" Tilt Touch Screen
LAN:
10/100BASE-T
to LAN
Tilt Clutch
9" Tilt Touch Screen: TPMC-9 • 23