Tilt Angle Tension Adjustment; Industry Compliance; Setup; Network Wiring - Crestron Isys TPS-12 Operation Manual

Tilt Touchpanels

Setup

14 ¥ Tilt Touchpanels: TPS-12/15/17

Tilt Angle Tension Adjustment

Use a 5/32 inch socket (supplied by other) with a hex drive key (Allen wrench) to
increase or decrease pivot tension at the base of the touchscreen. Turning the key
clockwise increases tension, counterclockwise decreases tension.
Tension Adjustment Screw

Industry Compliance

As of the date of manufacture, the TPS-12, TPS-15, and TPS-17 have been tested
and found to comply with specifications for CE marking and standards per EMC and
Radiocommunications Compliance Labelling.
NOTE: This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.

Network Wiring

CAUTION: In order to ensure optimum performance over the full range of your
installation topology, Crestron Certified Wire, and only Crestron Certified Wire, may
be used. Failure to do so may incur additional charges if support is required to
identify performance deficiencies as a result of using improper wire.
CAUTION: Use only Crestron power supplies for Crestron equipment. Failure to
do so could cause equipment damage or void the Crestron warranty.
®
Crestron Isys TPS-12/15/17
Operations Guide – DOC. 6375